Installation Guide

12 electrolux.com.au
REFRIGERATOR ALIGNMENT
Position the refrigerator in the cupboard so that:
1. Top hinge bracket is against cupboard wall (Figure 8).
2. Front of refrigerator cabinet (with doors open) is
parallel to and approximately 100mm from the front of
the cupboard (Figure 9).
3. Position bottom location brackets as shown (Figures
9 & 9a). Fit foot in appropriate hole as shown and
level refrigerator. (Figure 10)
NOTE: Do not screw in place yet.
NOTE: The front adjustable rollers may need raising (rotate
anti-clockwise when viewed from above) to achieve this.
Figure 8
Fridge
85mm
Top Hinge Bracket fitted – note the space between
the cupboard and the side of the refrigerator is to be
approximately 85mm.
Figure 9
100mm
INSTALLATION (CONTINUED)
Figure 9a - Hinge side
Figure 10
Height
adjustable
roller
Stability foot
4. Slowly close the cupboard door (pushing the
refrigerator back) until it is slightly ajar, i.e. with a gap
of about 4mm (Figure 11).
You may have to reposition the refrigerator back or forward
until the 4mm gap is obtained. Ensure that the refrigerator
remains parallel as you do this. Once you have the correct
gap, proceed to the next step.
Figure 11
4mm hinge gap
NOTE: The gap is left to ensure the refrigerator door will be
allowed to close fully for a good gasket seal.