420L Fridge Installation and Operations Manual
10 Using your refrigerator/Changing the light bulb Kelvinator Refrigeration
Changing the light bulb Using your refrigerator
This section tells you how to make the most of the many
useful features and how to clean them.
Door storage bins
Both refrigerator and freezer are tted with door storage
bins. You can adjust the refrigerator bins to meet different
storage needs. All the door bins are completely removable
for cleaning. If you want to remove or adjust a bin, lift it
over the support lugs on the inner door panel. To replace,
push the bin down over the support lugs to lock it in place.
Crisper bin
You can use the crisper bin to store vegetables, fruit or
smallgoods. You can change the humidity inside the bin
by sliding the humidity control.
You should store vegetables in the crisper bin remembering
to set the humidity control to more humid (closed).
You can also store fruit & smallgoods in the crisper bin
remembering to set the humidity control to less humid (open).
Changing the light bulb – Side by Side fridge
1. Switch off the power at the power point and remove
the refrigerator’s power cord from the power point.
2. Carefully unclip the light cover. You do this by inserting
your ngers behind the top of the light cover and pulling
it out while at the same time pushing it up at the bottom.
3. Pull the cover out until it is clear of the housing.
4. Unscrew the light bulb and replace it with a bulb that is
the same as the original.
5. Replace the cover by inserting the tab back into place
and pushing in the cover with both hands at the top.
6. Wait 5 minutes to ensure pressures in the refrigeration
system are equalized. Then reconnect and turn the
refrigerator on at the power point.
Changing the light bulb – Top and Bottom Mount fridge
1. Switch off the power at the power point and remove
the refrigerator’s power cord from the power point.
2. Carefully unclip the light cover. You do this by pushing
the light cover tabs at the front towards the back of
the cabinet, then lowering the cover down.
3. Unscrew the light bulb and replace it with a bulb that
is the same as the original, as specied on the rating
plate behind the cover.
4. Replace the light cover by hooking the light cover lugs
into the rear of the housing and pressing the front of
the cover until it clips in.
5. Wait 5 minutes to ensure pressures in the refrigeration
system are equalized. Then reconnect and turn the
refrigerator on at the power point.
Push Push
PullPull
Ta bTab
PushPush