Installation Guide

45
92.1% UPFLOW - 1 PIPE OPTIONS
Inline
Drain
VIEW -A-
VIEW -B-
VIEW -C-
Inline
Drain
FLUE PIPE
Plug
Plug
OPTION 1
OPTION 2
OPTION 3
Drain Line Attached to
1/2” x 1/2” Hose Barb
PVC TEE,
Reducer, &
1/2” x 1/2”
Hose Barb
X
FLUE PIPE
COMBUSTION
AIR
FLUE PIPE
See VIEW A for drain line positions See VIEW B for drain line positions
See VIEW C for drain line positions
FLUE PIPE
Plug
Plug
OPTION 4
OPTION 5
OPTION 6
PVC TEE,
Reducer, &
1/2” x 1/2”
Hose Barb
X
FLUE PIPE
FLUE PIPE
See VIEW A for drain line positions See VIEW B for drain line positions
See VIEW C for drain line positions
92.1% UPFLOW - 2 PIPE OPTIONS
COMBUSTION AIR
Plug
Plug
Plug
Plug
Plug
Rubber
Grommet
Rubber
Grommet
Rubber Grommet
Rubber
Grommet
Rubber Grommet
Rubber
Grommet
Flange
Flange
Flange
COMBUSTION
AIR
COMBUSTION
AIR
COMBUSTION AIR
COMBUSTION AIR
NOTES:
1.) All drain lines must be trapped with J-Trap or field supplied loop.
2.) Drain line traps may be positioned inside or outside the cabinet.
3.) Inline drain tubing may need to be cut to length to resemble illustration.
4.) See Accessories section (page 21-22) for optional PVC Tee configurations and drainage options.
5.) Header box drain tubing is routed thru the side of the cabinet.
6.) Inline drain tubing is routed thru the side of the cabinet.
7.) This drain not needed if “X” is less than 6”.
See NOTE 5
See NOTE 5
See
NOTES 6 & 7
See
NOTE 5
Figure35.UpowVentingOptions(*SCModels)