Use and Care Manual

7
NOTE: It is important to remember to press the PROG button
after you set your program because if you do not your settings will
not be saved.
Factory Program: HEAT
Weekdays
(M-F)
Weekends
(S-Su)
Interval Start Time Temp Start Time Temp
Morning 6:00AM 70 6:00AM 70
Day 8:00AM 62 8:00AM 68
Evening 6:00PM 70 6:00PM 70
Night 10:00PM 62 10:00PM 62
Factory Program: COOL
Weekdays
(M-F)
Weekends
(S-Su)
Interval Start Time Temp Start Time Temp
Morning 6:00AM 78 6:00AM 78
Day 8:00AM 85 8:00AM 85
Evening 6:00PM 78 6:00PM 78
Night 10:00PM 82 10:00PM 82
Your Program: HEAT
Weekdays
(M-F)
Weekends
(S-Su)
Interval Start Time Temp Start Time Temp
Morning
Day
Evening
Night
Your Program: COOL
Weekdays
(M-F)
Weekends
(S-Su)
Interval Start Time Temp Start Time Temp
Morning
Day
Evening
Night
8
You can press any of the interval buttons to review or change
your program at any time.
Using Voice Commands
One of the features that makes KELVIN unique is the ability to
raise and lower the temperature by using voice commands.
Initiate voice control by pressing the RAISE or LOWER button.
KELVIN will tell you the time and temperature, and await your
command. There are two possible commands “raise” and
“
lower”. If you say, “raise”, KELVIN will increase the current set
temperature by one degree. You can then say “raise” again and
increase the temperature another degree. KELVIN will wait 15
seconds before it stops listening for your command. KELVIN
responds to “lower” in the same manner, by decreasing the
current set temperature by one degree