Use and Care Manual

5
SETTING THE DAY
Press the
SET DAY
button. The thermostat will advance one day
on the display for each press of the SET DAY button. Keep
pressing the button until the correct day is displayed.
Programming Temperature Intervals
The KELVIN thermostat comes preprogrammed with a
temperature control schedule that will work for most household
situations. See page 7 for a table of the factory program.
KELVIN is a 7 day programmable thermostat. That means that
you can set different time and temperature profiles for each day of
the week.
If the factory program is not to your liking, you can program
KELVIN to your own comfort and savings profile.
6
Programming KELVIN

Press the
MORNING
interval button. This button is located under
the door. The thermostat’s display will show the time of day and
the day of the week that this interval will start. The display will
also show what temperature is set for that time interval.
KELVIN defaults to running a weekday and weekend program
(5+2). The thermostat also gives you the ability to set a different
time and temperature for any day of the week (7 day). If you
would like to use the 5+2-programming mode, make sure that the
display shows Mon-Fri on the display. If you would like to use the
7-day mode, then press the
SET DAY
button until you reach the
desired day.
Next press the SET TIME button. The hours will begin to flash.
Use the
RAISE
and
LOWER
buttons to set the desired time.
After you have reached the desired hour press the
SET TIME
button again. Follow the same procedure for minutes. The time
you are setting is the start time for this interval. You do not have
to program an end time, because the next interval will
automatically start at the programmed time. After you are done
programming the time, press the
SET DAY
button and repeat the
steps for above for each day or days that are desired. See the
chart below for assistance in the programming process. Fill in the
chart with all of your desired times and temperatures.
When you’re done programming the last interval, press the
PROG
button.