Instructions / Assembly

10
Setting the day
Press the
SET DAY
button. The thermostat will advance one day
for each press of the
SET DAY
button. Keep pressing the button
until the correct day is reached.
If you disabled the sound you should re-enable it now by pressing
the
VOICE
button again. KELVIN comes preprogrammed with a
factory default program. To modify the program please refer to
the operations manual.
11
Testing KELVIN
Snap the thermostat body onto the wall plate and set it to heat
mode. Press the up button and raise the temperature at least 2
degrees more then the current temperature. Wait a minute or so
and verify that your heat has turned on. You should hear a click
when the thermostat enables the heating system. After you
verified that the heating system works turn the temperature back
down to the desired level. The cooling system can be tested in a
similar manner, but the thermostat needs to be set to cool.
Using KELVIN
One of the features that makes KELVIN unique is that you can
raise and lower the temperature by using your voice. To do this
walk over to the thermostat and press either the up or down
button. The thermostat will then tell you the time and
temperature. After that it will be waiting for your instructions.
There are two possible commands “raise” and “lower”. If you say,
“raise” KELVIN will raise the current set temperature 1 degree.
You can then say “raise” again and change it another degree.
KELVIN will listen for 15 seconds before it stops listening for your
command. KELVIN will also respond to “lower” in similar manner
however it will lower the temperature by one degree instead of
raising it.