User's Manual

SBS-900 Shore Based Radar Systems
Chapter 8: Service display/ RadarView control
KH-1602-2 issue 1: Standard SBS900 Systems Operator & Maintenance Handbook
Page 77 of 240
8.8 Switching ON/ OFF
SBS-A3-2: Third party system
The operation of third party PC equipment used in the SBS-A3-2 service display is not detailed within
this handbook. Please refer to the user manuals supplied with the original third party equipment.
SBS-A3-X: 2U 19 inch processor rack
The following details the switching ON/ OFF of the microprocessor used in the SBS-A3-3, -4
& -5.
Switch ON
i. Ensure an AC mains supply is connected to the system and is switched
ON (115/ 230VAC auto-ranging)
ii. Open the front panel of the service display processor.
iii. Place the power switch into the ON ( I ) position.
iv. The green power LED illuminates and the processor will start.
Run RadarView
application
When the service display has started, run the RadarView
application from the desktop.
A brief overview of the operation of RadarView software
can be found in the following section.
RadarView desktop icon
Reset
If a system lockup or freeze occurs, temporarily press the Reset switch which
restarts the processor.
Caution: Pressing reset aborts all programs that are running. All unsaved work and
temporary configurations will be lost. The main system configurations and settings are
retained.
Closing the
RadarView
application
Prior to switching the OFF service display, the RadarView application must be
closed.
Shut-down and
switch OFF
Ensuring the RadarView application has closed, shut down the system using
the Start/ shutdown function from the Windows desktop.
When Windows has shut-down, place the power switch into the OFF (0)
position or if the switch is spring loaded, press and hold the OFF button for 5
seconds)