User's Manual

SBS-900 Shore Based Radar Systems
Chapter 6: Local operation instructions
KH-1602-2 issue 1: Standard SBS900 Systems Operator & Maintenance Handbook
Page 65 of 240
6.6.5.1 Brightness
Brightness is used to set the backlight brilliance of the LCD front panel on the Radar Distribution Unit.
Bright
+
Increases the backlight brilliance of the front panel.
Bright -
Decreases the backlight brilliance of the front panel.
6.6.5.2 Variant Options
The Variant Options menu shows the system configuration.
SBS variant Shows the SBS system number
i.e.
SBS
-
900
-
1
.
CAN Mode Shows the CAN mode as OFF, RIU, TIU or Fixed.
CAN Address
To Be Confirmed
.
TX PSU CONT Set to Always ON in SBS-900 systems.
Days to Swap
Shows the number of days until the transceiver automatically swaps (Dual transceiver
systems only).
Door switch Enabled where a Hut door security switch is connected.
WG dryer
Enable
d when the optional
pressurized waveguide dryer is
i
nstalled.
Platform switch Enabled where an Antenna Platform security switch is fitted.
Horizontal POL
Enabled when a polarised antenna is being fitted.
Circular POL
Anti-clock POL
Vertical POL
ENH Encoder Fitted is displayed when an enhanced encoder is installed.
Oil status
Enabled when the optional oil monitoring input from the Advanced antenna Turning Unit is
installed.
Fan Bank A
Enable or disable the optional powered fan kit for Tx A.
Note: In single Transceiver systems, this menu may not be present.
Fan Bank B
Enable or disable the optional powered fan kit for Tx B.
Note: In
single Transceiver systems, this menu may not be present.
Active Fan
Set the temperature that Fan Bank A switches on or set to permanently ON.
Note: In single Transceiver systems, this menu may not be present.
Reserve Fan
Set the temperature that Fan Bank B switches on or set to permanently ON.
Note: In single Transceiver systems, this menu may not be present.
Minimum FREQ Displays nb_ gchcgog [p[cf[\f_ Rb[ljDs_x `l_ko_h]s.
Maximum FREQ
Displays
nb_ g[rcgog [p[cf[\f_ Rb[ljDs_x `l_ko_h]s
.
Low RPM Enabled when LOW RPM antenna speeds have been commissioned.
High RPM
Enabled when HIGH RPM antenna speeds have been commissioned.
Auto RPM Enabled when AUTO RPM antenna speeds have been commissioned.
Alt Chan Plan
This allows the system to
Note: System
specific menu, this may not be present in standard system.
Ant Gain
Allows the selection of the antenna gain when Alt Chan Plan is selected.
Note: System specific menu, this may not be present in standard system.
EXIT
Exits the Variant Options Menu
.
6.6.5.3 Serial Ports
The serial ports menu displays the baud rates configured for the serial outputs to the transceiver,
Service Display (SKL: Service display serial port) or the optional analogue track extractor (SKK: TE
serial port).
TE port Displays the Baud Rate for the Track Extractor (TE) output
Service port
Displays the Baud Rate for the Service Display.
TX/ RX A Ccmjf[sm nb_ A[o^ Q[n_ `il nb_ Rb[ljDs_x SW . Qr @-
TX/ TX B
Ccmjf[sm nb_ A[o^ Q[n_ `il nb_ Rb[ljDs_x SW . Qr A-
EXIT
Exits the Serial Ports menu