User's Manual

SBS-900 Shore Based Radar Systems
Chapter 6: Local operation instructions
KH-1602-2 issue 1: Standard SBS900 Systems Operator & Maintenance Handbook
Page 58 of 240
6.6.4.3 SharpEye
By scrolling through the SharpEye Tx A or SharpEye Tx B menus (see table below), the following
transceiver conditions can be viewed but cannot be adjusted.
Note: In Single transceiver systems, the Tx A or Tx B menu may not be available.
System Transceivers TX A Tx B
SBS
-
900
-
1
Single
X
-
band
N/A
SBS
-
900
-
2
Single
X
-
band
N/A
SBS
-
900
-
3
Dual
X
-
band
X
-
band
SBS
-
900
-
4
Dual
X
-
band
S
-
band
SBS
-
900
-
51
Single
N/A
S
-
band
SharpEye HL Shows the antenna RPM based on HL frequency.
Azimuth
Shows the value of the azimuth being received or Fail if no signal
is
present. The normal value is 4096.
Video Shows if the video is OK (present) or Fail if no signal is present.
Sync
Shows the current Sync value (PRF) or Fail if no signal is
present
.
Blanking Shows if blanking is OK (present) or Fail if no signal is present.
Status 0: Mode
&
Run Mode
Standby or Run
.
Mute ON or OFF.
Range
24nm or 48nm
.
Frequency SharpEye
TM
transmission frequency (1 to 7).
Sweep
Forward or reverse
.
Power High or Low.
RPM
Shows the
RPM as detected by the SharpEye
TM
25us Pre sync
Pre-sync from the SharpEye
TM
transceiver
Enabled or Disabled.
Video range
Show the instrumented video range in
µ
s
.
Status 1: Alarm
&
RX
Receiver OK or
F
ail
.
VSWR
VSWR OK or Fail ~ if Fail the transceiver
automatically switches to low power mode
.
T
X power
Output power OK or
F
ail
.
PLO
Programmable
Local
oscillator OK or
F
ail
.
SYNTH
SharpEye
TM
internal synth OK or
F
ail
.
Temp
Internal temperature OK
, warning or
shutdown
.
Turning
Antenna t
urning data OK or
F
ail
.
HL
Heading line
(ARP)
OK or
F
ail
.
AZ IN
Azimuth in
(ACP)
OK
, reverse
or
F
ail
.
FPG
A2
FPGA 2 OK or
F
ail.
Status 2: GSR
&
Sea
Sea clutter: 000 (minimum) to 255 (maximum)
.
Rain Rain clutter: 000 (minimum) to 255 (maximum).
Int Rej Shows the current Interference Rejection
setting
.
Doppler filter
Select levels of 4, 8, 16, 32 or 64
.
Continued on following page