User's Manual

SBS-900 Shore Based Radar Systems
Chapter 6: Local operation instructions
KH-1602-2 issue 1: Standard SBS900 Systems Operator & Maintenance Handbook
Page 46 of 240
6.5 Switch from Local to Remote
When Local control is no longer
required, the system MUST be
switched to Remote.
Caution: If the system is left in Local
mode, remote operation by the
command & display system or Track
Extractor will NOT BE POSSIBLE.
Changeover: The system can only be changed from Local to Remote control using the switch on the
Radar Distribution Unit; it is not possible to remotely change from Local to Remote.
6.5.1 Set to RUN & switch to Remote
The system can be set to Remote before the track extractor is on-line or ready (see below), this may
be desirable when handing the system back to the Remote operating station.
Local
selected
With Local selected use the front panel or service
display to place the transceiver into RUN.
Ensure the system is transmitting and is configured as
required for operation.
Switch
to
Remote
Switch from Local to Remote.
The system continues to transmit and is ready to accept control
commands from the command & display system or track extractor.