User's Manual

SBS-900 Shore Based Radar Systems
Chapter 10: Corrective maintenance
KH-1602-2 issue 1: Standard SBS900 Systems Operator & Maintenance Handbook
Page 206 of 240
Links (factory defaults in BOLD)
LK10
Position A Isolated output
Parallel 1
Position B
Opto
-
isolated output
LK11
Open
Normally open output contact
Position A
Position B
Normally closed output contact
LK12
OPEN Isolated output
Position A
Non
-
isolated output ground
Position B Non-isolated output +15V
LK13
OPEN
Opto-isolated input
MADE
Isolated output
LK14
Position A Isolated output
Parallel 2
Position B
Opto
-
isolated output
LK15
Open
Normally open output contact
Position A
Position B
Normally closed output contact
LK16
OPEN Isolated output
Position A
Non
-
isolated output ground
Position B Non-isolated output +15V
LK17
OPEN Opto-isolated input
MADE
Isolated output
LK18
Position A Isolated output
Parallel 3
Position B Opto-isolated output
LK19
Open
Normally open output contact
Position A
Position B
Normally closed output contact
LK20
OPEN Isolated output
Position A Non-isolated output ground
Position B
Non
-
isolated output +15V
LK21
OPEN Opto-isolated input
MADE
Isolated output
LK22
Position A Isolated output
Parallel 4
Position B Opto-isolated output
LK23
Open
Normally open output contact
Position A
Position B
Normally closed output contact
LK24
OPEN Isolated output
Position A Non-isolated output ground
Position B
Non
-
isolated output +15V
LK25
OPEN Opto-isolated input
MADE
Isolated output
Test points
TP1
Ground / 0V
TP2
Ground / 0V
Power
The PCB uses +15V and +3.3V supplies directly from the backplane.
A +5.0V DC rail is generated on the PCB from the +15V supply, LED D1 (green) is lit when this +5.0V
supply is present.