User's Manual

Restoration of System Con fig uration in the event of Hard Disk Fail ure
38 On installation the system configuration data is stored on the hard disk. A back-up of this
data is taken after installation. This back-up must be stored so that it can be used to restore
the system in event of hard disk failure. The menus used to backup and restore the configuration
data are password protected and are not available to the user.
39 Map and route data is also stored on the hard disk. The user should take regular backups
to removable media (memory stick) for restoration in the event of hard disk failure.
40 Therefore, in the event of hard disk failure the configuration data is restored from:
(1) The back-up data taken by the installer after installation is complete, which
allows the configuration data to be restored.
(2) Map and Route data taken by the user at regular intervals, which allows the
current maps and routes to be restored.
41 The data is restored from the removable media onto the new hard disk. Hard disk
replacement and restoration of data must be undertaken by a Kelvin Hughes service
engineer or approved agent.
NOTE: Data is restored from Set-Up Mode. This menu is password protected and is only
available to authorised personnel. Refer to Ship's Manual KH2061 for further
information.
Issue 5 (Jan 09) Page 4.13
KH2060-4