User's Manual

KH2060-2
SWITCHING ON AND OFF
SWITCH ING ON
1 Press the System ON/OFF button on the Visual Display Unit (located below the screen)
to switch the system on. The operating system will boot up and the Standby screen will be
shown. If necessary, using the Trackerball and Button Backlight and Screen Backlight
controls set up the required level of backlighting.
2 If the system does not start up, check the following:
(1) Check that the radar sensors are switched on, as follows:
(a) If a Drive Control Unit is fitted, ensure the key on the top of the unit is set to
ON. The MOTOR ON indicator will light indicating that power is applied
to the antenna.
(b) If a Transmitter Interface Unit (TIU) is fitted, ensure the ON/OFF switch on
top of the unit is set to ON.
(2) If a Radar Interswitch Unit (RIU) is fitted ensure the switch on the base of the unit
is set to ON (note that it is normally left in the ON position when the radar system
is not in use).
(3) Check that the ON/OFF switch on the Processor Unit is switched on (note that it
is normally left in the ON position when the radar system is not in use).
3 Refer to KH3200, bound in Section 2 of this manual, for the Radar operating procedures.
CON TROL FUNC TIONS
4 The Display Select control is only used on multi-function displays in an Integrated
Bridge System or Integrated Navigation System, and allows the user to view Processor
Units which have different functionality, e.g. Radar, ECDIS, Conning Display.
5 The System Alarm will be lit brightly in red and an audible alarm will sound if a system
fail is detected. Pressing the button acknowledges the alarm and silences the audible
alarm. A system alarm is initiated by the watchdog timer on the Processor Unit and indicates a
problem in the Processor Unit.
Issue 5 (Jan 09) Page 2.3
KH2060-2
SYSTEM
ALARM
TRACKERBALL
AND BUTTON
BACKLIGHT
SCREEN
BACKLIGHT
DISPLAY
SELECT
SYSTEM
ON/OFF
DOWN
UP
CD-7406
ISSUE 1