User's Manual

37 The MantaDigital Control Interface (MCI) incorporates controls for:
(1) Gain rotary control.
(2) Rain anti-clutter rotary control.
(3) Sea anti-clutter rotary control.
(4) EBL 1 and EBL 2 On/Off buttons, with a rotary control to set the position of the
selected EBL.
(5) VRM 1 and VRM 2 On/Off buttons, with a rotary control to set the range of the
selected VRM.
(6) Chart On/Off button.
(7) Vector Mode select button to select True or Relative vectors.
(8) Brilliance button. This button sets the brilliance of the MantaDigital Control
Interface backlight. Press the button to increase brilliance. Once maximum
brilliance is achieved the MantaDigital Control Interface backlight goes to
minimum brilliance and brilliance starts to increase brilliance again.
(9) PI On/Off button, switches parallel index lines on and off.
(10) AIS On/Off button, switches AIS on and off.
(11) HL Off button, when pressed temporarily removes heading line and all other
graphics, except the radar image, from the Radar Operational Area.
(12) Range + and - buttons, to set the range scale.
(13) Alarm Cancel button, silences the audible alarm.
(14) F1 and F2 functions buttons are user configurable to meet operational
requirements.
Page 1.18 Issue 5 (Jan 09)
KH2060-1