User Manual

ManualsBrandsKelung ManualsIP ExtenderKelung KLXX000X WLAN IP Extender

Table Of Contents

ANT

Turn on electricity after Wlan IP extender connecting with antenna. Should be aligned the

transmitting antenna with the receiving antenna and not deviate from each other.

Wlan IP extender connect with antenna to transfer signal automatically. Installer can use their

own device through RJ45 cable. The Wlan IP extender use DC12v power which pass the FCC

certification.

Wlan IP extender

RJ45 cable

User manual

DC12V DC12V

Summary of content (5 pages)

PAGE 1
User manual Wlan IP extender Wlan IP extender RJ45 cable ANT DC12V ANT DC12V Turn on electricity after Wlan IP extender connecting with antenna. Should be aligned the transmitting antenna with the receiving antenna and not deviate from each other. Wlan IP extender connect with antenna to transfer signal automatically. Installer can use their own device through RJ45 cable. The Wlan IP extender use DC12v power which pass the FCC certification.
PAGE 2
The manufacturer will set the channel in default mode, but installers can set the channel themselves according the environment.
PAGE 3
The antenna installation position is according to the control center. The RX box should install near the control center. The Transmitter and Receiver box are the same units. The manufacturer will setup in TX or RX mode and it would label it. So the installer will know the installation process.
PAGE 4
FCC Compl i ance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device must not cause harmful interference, and 2. This device must be able to withstand any interference received, including interference that may cause undesired operation. FCC War ni ng This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 5
FCC RFRadi ati on Exposure This equipment complies with the FCC RF radiation exposure limits stipulated for an uncontrolled environment. This device and its antenna must not be co-located or operated in conjunction with any other antennas or transmitters.