Owner Manual

Page 7 of 7

Each slat (#7) has 2 slat support legs (#7). Align the threaded ends of

the 2 slat support legs (#8) with the pre-drilled hole of the slat (#7) and

tighten by hand until secured. Repeat the process to assemble the

remaining 6 slat support legs (#8) onto the remaining 3 slats (#7).

ASSEMBLY IS COMPLETED

#J x 8 pcs

I. Align the ends of the assembled

slat (#7) with the pre-drilled holes

on each side of the side rails (#6).

II. Secure two screws (#J) onto each

end of the slat (#7) using a Phillips

screwdriver to tighten them down

to the side rails (#6). Repeat the

process for the remaining 3 slats

(#7).

III. Make sure the bed is rested on a

flat surface and does not feel loose

or wobbly. If it does, double check

that the bolts/screws are secured

and properly tightened.

Turn right (clockwise) to tighten