Owner Manual

Page 6 of 7
Turn right (clockwise) to tighten
#F x 8 pcs
#G x 8 pcs
#H x 8 pcs
I. Insert 4 threaded studs (#F)
into the right headboard leg
(#2R) and the left headboard
leg (#2L).
II. Insert one side rail (#6) onto
the two threaded studs (#F)
on the right headboard leg
(#2R). Then insert 2 beveled
washers (#H) onto the 2
threaded studs (#F) and
secure with the 2 hex nuts
(#G) using the wrench (#I) to
tighten. Repeat the process
to secure the other side rail
(#6) onto the left headboard
leg (#2L).
III. Repeat the process above to
assemble the other ends of
the 2 side rails (#6) onto the
footboard (#4).
Align the threaded ends of the 2 footboard feet (#5) with the pre-
drilled holes on the bottom of the footboard (#4) and tighten by hand
until secured.
Turn right (clockwise) to tighten