Installation Instructions

(2) 1/4"-20 Hex Head

Cap Screws

3/4" Long

No Gap

Feet are flush with

floor

Correct Setup

Gap

Feet are not

flush with floor

Gap

Feet are

not flush

with floor

Lower Section is

Too Long

Step

5 ATTACHING THE FEET

TOOLS

NEEDED

INCLUDED COMPONENTS & FASTENERS

Hacksaw

Tape Measure

Pencil

Drill

9/32" Drill Bit

Carpenter’s Square

Wrench, 7/16" (2)

(1) Right Foot

Assembly

(1) Left Foot

Assembly

WARNING

The bottom section must fit flush with the floor. Failure to properly adjust the feet on the ladder could result in

unnecessary stress on the component parts, resulting in serious injury.

Lower Section is

Too Short

At the completion of Step 5 the hinges in your ladder should have

no gaps as shown in the Correct Setup

(2) 1/4"-20

Lock Nut