Manual

Service
Should your firearm require adjustment, or
repair, it should be returned unloaded to the
factory. Always remove any non factory
accessories including scopes and muzzle
devices before sending in for repairs. Kel-Tec
CNC IND INC cannot be held responsible for
lost or damaged accessories sent in with the
firearm. In shipping the firearm, be sure to
adhere to the following rules:
Individuals who wish to return the firearm for
service can do so by shipping via UPS prepaid.
No return authorization number is required.
Include a letter of instruction, full name,
address, phone number, email and the gun’s
serial number. Retain a copy of the serial
number for your records to use in tracking
your repair. This will insure prompt service and
handling once your pistol has been received.
You will receive a quotation for anything other
than warranty work. You will be notified of full
charges and no work will commence before
receiving your approval of our quotation if non-
warranty work is necessary. Please see the
warranty page at the end of this manual or
contact Kel-Tec directly for more details. All
quotations are payable by C.O.D., VISA, M.C.
or money orders only. No personal checks
accepted.
Always use polymer-safe solvents designed
for firearms when cleaning polymer firearm
parts.
Routine cleaning, after every shooting
session:
Your firearm should be cleaned by brushing
the barrel bore and chamber with a good
powder- removing solvent and bore brush.
Wipe the areas clean with patches or a swab.
Using a small brush dipped in solvent, remove
all deposits from around the breech of the
barrel, bolt face, and chamber and adjacent
areas which have been subjected to the action
of powder or primer residue. Remove any
residue on the frame with light brushing and a
polymer safe solvent. After cleaning the entire
gun, use a cloth to apply a light coating of high
quality gun oil to all external surfaces and wipe
clean.
Additional cleaning, after firing 500 to
1000 rounds:
Remove the bolt assembly as stated in the
disassembly section of this manual. Thoroughly
clean with solvent and a brush the bolt face
and all sides of the bolt. Brush around the
extractor and firing pin. Thoroughly dry all
parts. Apply a light coat of oil to the exterior
surfaces of the bolt and wipe off any excess.
Apply a light coat of oil on the recoil spring
guide and re-install the bolt assembly and
firearm as stated in the assembly part of this
manual. DO NOT FORGET TO REINSTALL
THE BUFFER. Manually cycle the bolt back and
forth to check the function of the firearm. If any
parts are damaged or badly worn or the
firearm does not work correctly the firearm
should not be fired and should be returned to
Kel-Tec for servicing immediately.
LUBRICATION WARNING:
Firing a firearm with oil, grease, or any
other material even partially obstructing
the bore may damage the pistol and
injure the shooter and those nearby.
Do not spray or apply lubricants directly
on ammunition. If the powder charge of
a cartridge is affected by the lubricant, it
may not be ignited, but the energy from
the primer may be sufficient to push the
bullet into the bore where it may
become lodged. Firing a subsequent
bullet into the obstructed bore will
damage the pistol and may injure the
shooter and bystanders. Use lubricants
properly. You are responsible for the
proper care and maintenance of your
firearm.
WARNING:
It is not recommended that you disas-
semble the grip or stock; the hammer
spring is constantly under tension and
can easily injure you or others. If the
need arises to lubricate the trigger
assembly do so through the access slot
behind and in front of the hammer.
16 17