KEL-TEC PLR-22 Pistol and SU-22 Rifle SAFETY, INSTRUCTION & PARTS MANUAL STATEMENT OF LIABILITY This firearm may be classified as a dangerous weapon and is surrendered by KEL-TEC CNC INDUSTRIES INC. with the understanding that the purchaser assumes all liability resulting from unsafe handling or any action that constitutes a violation of any applicable laws or regulations. Firearms can cause serious injury and death. Safety must be the prime consideration of anyone who handles firearms.
SAFE GUN HANDLING IS YOUR RESPONSIBILITY READ AND CAREFULLY FOLLOW THESE WARNINGS AND INSTRUCTIONS Make sure your “audience” is always 5 feet behind you, not next to you when firing. These warnings and instructions are provided to assure the safe functioning of the firearm. Failure to heed them may result in improper functioning and serious injury. Keep your firearm unloaded when not in use. Never keep a loaded firearm in the home or vehicle. Never store a firearm with a cartridge in the chamber.
INTRODUCTION The PLR-22 pistol and SU-22 rifle are semiautomatic firearms chambered for the .22 Long Rifle (.22LR) cartridge. They will accept most standard Atchison style M-16 .22LR conversion magazines. INSTRUCTIONS FOR USE Safety To achieve operator safety, combined with ease of handling, the PLR-22 pistol’s and SU22 rifle’s manual safety, when applied, positively blocks the trigger from rotating the sear. The safety can be applied at any time, whether the hammer is cocked or not.
loading until you have loaded the number of cartridges you wish to load, up to the normal magazine capacity of 27 rounds, unless noted differently on your magazine. Do not attempt to load your magazine with more than the specified number of rounds. Doing so can damage the magazine and can cause a feeding malfunction. Before inserting a loaded magazine always tap the back of the magazine against a hard surface two or three times in order to properly seat all the cartridges to the rear of the magazine.
the bolt is in the forward position and the safety is engaged. DISASSEMBLY NOTE: Disassembly can be performed with only a small screwdriver or a small punch. None of the screws on the pistol should ever need to be removed for general maintenance. CAUTION: Some accessories that are mounted to the picatinny rail on the top of the receiver may interfere with the disassembly of the firearm. It is advisable to remove any scopes or other devices mounted to the rail before proceeding with disassembly.
12 13
SIGHT ADJUSTMENT Push the operating handle all the way forward, the recoil spring tube should line up with the protrusion on the front sight. Grip the recoil spring tube, pull it forward and twist it 1/4 turn so that the locking tab on the recoil spring tube goes into the receptacle on the left side of the receiver.
parts are damaged or badly worn or the firearm does not work correctly the firearm should not be fired and should be returned to Kel-Tec for servicing immediately. Always use polymer-safe solvents designed for firearms when cleaning polymer firearm parts. Routine cleaning, after every shooting session: Your firearm should be cleaned by brushing the barrel bore and chamber with a good powder- removing solvent and bore brush. Wipe the areas clean with patches or a swab.
WARRANTY Transportation and insurance charges for return to owner will be paid by Kel-Tec if the claim is covered by the warranty. This warranty is granted by Kel-Tec CNC Industries, Inc. P.O. Box 236009, Cocoa, FL 32923. This lifetime warranty is effective from the date of purchase and applies to the original owner of a Kel-Tec firearm.
