Brochure
1.888.KEITHLEY (U.S. only)
www.keithley.com
Side Text
ACCESSORIES
A GREATER MEASURE OF CONFIDENCE
Cables
Cables
Model 7078-CSHP is a set of eight 3m (10
ft) cables and four BNC-to-triax adapters for
connecting between the Model 7072 8×12
Semiconductor Matrix Card and an HP-4145
Semiconductor Parameter Analyzer. Four 3-slot
triax cables connect to Source/Mea s ure Unit
outputs. Four BNC-to-BNC coax cables adapt
the measurement and source modules in the
HP-4145 to the connectors of 7072.
For use with: 7072 to HP-4145
Model 7078-DIN: This 1.8m (6 ft) cable ac ces-
sory connects between Model 707A main frames
when operated as one unit in Master/Slave
mode. One cable is required for each mainframe.
For use with: 707A
Model 7078-MTC-5: 1.5m (5 ft) mass terminated
cable for connection to column inputs (7071 and
7071-4). Also used for matrix expansion (7071,
7071-4, or 7074). The cable has 12 sets of shielded
twisted pair wires for isolation of critical circuits
and noise rejection in the system. The cable is ter-
minated at each end in a 38-pin connector block
with strain relief. Model 7078-MTC-20 can be
used as is or cut in half to make two 10 ft cables.
For use with: 7071, 7071-4, 7074-D
3 Slot Triax
Model 7078-TRX-* 3-slot Triax Cables: Low
noise triax cables terminated at both ends in
3-slot male triax connectors.
7078-TRX-1 0.3m (1 ft)
7078-TRX-3 0.9m (3 ft)
7078-TRX-5 1.5m (5 ft)
7078-TRX-10 3.0m (10 ft)
7078-TRX-12 3.5m (12 ft)
7078-TRX-20 6.0m (20 ft)
For use with: 237, 2635A, 2636A, 6220, 6221,
6487, 6514, 6517A, 6517B, 7072, 7174A
3 Slot Triax
Model 7078-TRX-6IN 3-slot Triax Cable: 0.15m
(6 inch), 3-slot, low-noise, guarded triax cable that
minimizes leakage current and input capacitance
when used with the Model 6430 Remote PreAmp
(lower noise than 1 foot or longer versions).
For use with: 6430
Model 7152-MTC-*: Five low noise triax cables
terminated in 6-position M-series coax connec-
tor blocks. Provides quick connection between
7152 matrix cards and is compatible with Model
7152-MTR connector. Also available in 3m (10 ft)
length for connection between the matrix and
the device under test.
7152-MTC-2 0.6m (2 ft)
7152-MTC-10 3.0m (10 ft)
For use with: 7152