Datasheet

Section 9: Pulse Testing High-Brightness LEDs Model 2461 Interactive SourceMeter® Instrument User's Manual
9-4 2461-900-01 Rev. A / November 2015
The figure below shows the rear-panel connections. You can make these connections with either the
Model 2460-KIT Screw-Terminal Connector Kit (included with the Model 2461) or a Model 2460-BAN
Banana Test Leads/Adapter Cable with appropriate cabling.
Figure 51: Model 2461 4-wire connections to the rear panel
High-speed, high-power pulses from a remote interface
In this application, the Model 2461 is configured from a remote interface to generate a high-power
pulse sweep using Test Script Processor (TSP
®
) commands. A current reading is made during each
pulse.
To ensure precise timing control, you will specify pulse parameters, configure the voltage source and
current measurements and set up the trigger model to control the timing of the pulses and
measurements.