Datasheet

Section 6: Rechargeable battery measurements Model 2461 Interactive SourceMeter® Instrument User's Manual
6-8 2461-900-01 Rev. A / November 2015
Send the following commands for this example application:
SMU
command or
pseudocode
Commands
Description
SMU
command
OUTP:SMOD HIMP
SENS:CURR:RSEN ON
SOUR:FUNC VOLT
SOUR:VOLT 0.9
ROUT:TERM REAR
SOUR:VOLT:READ:BACK ON
SOUR:VOLT:RANG 2
SOUR:VOLT:ILIM 2.5
SENS:FUNC "CURR"
SENS:CURR:RANG 4
OUTP ON
 Turn on high-impedance output mode.
 Set to 4-wire sense mode.
 Set to source voltage.
 Set source level to 0.9 V.
 Select the rear-panel connections.
 Turn on source readback.
 Set source range to 2 V.
 Set the source limit to 2.5 mA.
 Set to measure current.
 Set current range to 4 A.
 Turn the output on.
Pseudocode
iteration = 1
voltLimit = 0.9001
current = []
voltage = []
seconds = []
hours = []
while true do:
 Create a variable called iteration and
initialize to 1.
 Create a variable called voltLimit and
initialize to 0.9001.
 Create an empty array for current
measurements.
 Create an empty array for voltage
measurements.
 Create an empty array for the time values.
 Start a while loop.
SMU
command
current[iteration] = READ?
"defbuffer1"
voltage[iteration] = TRAC:DATA?
iteration, iteration,
"defbuffer1", SOUR
seconds[iteration] = TRAC:DATA?
iteration, iteration,
"defbuffer1", REL
 Append the current reading to the array
current.
 Append the voltage reading to the array
voltage.
 Append the time reading to the array
seconds.
Pseudocode
hours[iteration] =
seconds[iteration]/3600
print(voltage[iteration],
current[iteration],
hours[iteration])
if voltage[iteration] <=
voltLimit then:
break
end if
iteration = iteration + 1
delay(10)
end while
 Calculate the hours taken at each iteration.
 Print the measured values.
 Compare the voltage reading from this
iteration to the voltage limit. If the
measured value is less than or equal to the
limit, break out of the loop.
 End the if statement.
 Increment the iteration count by 1.
 Delay for 10 seconds.
 End the while loop.
SMU
command
OUTP OFF
 Turn the output off.