Instructions
Table Of Contents
- Model DMM6500 6½-Digit Multimeter User's Manual
- 1 Introduction
- 2 Front-panel overview
- 3 Using a remote interface
- 4 Making basic front-panel measurements
- 5 Measuring DC voltage with high accuracy
- 6 Measuring 4-wire resistance with offset compensation
- 7 Scanning temperature at a set time interval
- 8 Grading and binning resistors
- 9 Measuring power using digitizing and TSP-Link
- 10 Troubleshooting FAQs
- About this section
- Where can I find updated drivers?
- Is there any software to help me get started?
- Why did my settings change?
- Why can't the DMM6500 read my USB flash drive?
- How do I upgrade the firmware?
- How do I change the command set?
- How do I save the present state of the instrument?
- How do I save what is displayed on the screen?
- What is the ethernet port number?
- 11 Next steps
- Contact information
In this section:
Additional DMM6500 information ........................................... 11-1
Additional DMM6500 information
This manual has prepared you to start using your new DMM6500 6½ Digit Multimeter for your
application. For more detailed information, refer to the Keithley Instruments Model DMM6500
Reference Manual.
Also see tek.com/keithley
for support and additional information about the instrument. From the
website, you can access:
• The Knowledge Center, which contains the following handbooks:
The Low Level Measurements Handbook: Precision DC Current, Voltage, and Resistance
Measurements
Switching Handbook: A Guide to Signal Switching in Automated Test Systems
• Application notes
• Updated drivers
• Information about related products
Your local Field Applications Engineer can help you with product selection, configuration, and usage.
Check the website for contact information.
Section 11
Next steps