Instructions
Table Of Contents
- Model DMM6500 6½-Digit Multimeter User's Manual
- 1 Introduction
- 2 Front-panel overview
- 3 Using a remote interface
- 4 Making basic front-panel measurements
- 5 Measuring DC voltage with high accuracy
- 6 Measuring 4-wire resistance with offset compensation
- 7 Scanning temperature at a set time interval
- 8 Grading and binning resistors
- 9 Measuring power using digitizing and TSP-Link
- 10 Troubleshooting FAQs
- About this section
- Where can I find updated drivers?
- Is there any software to help me get started?
- Why did my settings change?
- Why can't the DMM6500 read my USB flash drive?
- How do I upgrade the firmware?
- How do I change the command set?
- How do I save the present state of the instrument?
- How do I save what is displayed on the screen?
- What is the ethernet port number?
- 11 Next steps
- Contact information
Section
10: Troubleshooting FAQs Model DMM6500 6½ Digit Multimeter
User's Manual
10-6 DMM6500-900-01 Rev. B / August 2019
How do I save what is displayed on the screen?
You can save a screen capture of the front-panel display to a graphic file on a USB flash drive. The
instrument saves the graphic file in PNG file format.
To save a screen capture:
1. Insert a USB flash drive into the USB port on the front panel of the instrument.
2. Navigate to the screen you want to capture.
3. P
ress the HOME and ENTER keys. The instrument displays “
Saving screen capture.”
4. Release the keys.
What is the ethernet port number?
The port number is 5025.