Instructions
Table Of Contents
- Model DMM6500 6½-Digit Multimeter User's Manual
- 1 Introduction
- 2 Front-panel overview
- 3 Using a remote interface
- 4 Making basic front-panel measurements
- 5 Measuring DC voltage with high accuracy
- 6 Measuring 4-wire resistance with offset compensation
- 7 Scanning temperature at a set time interval
- 8 Grading and binning resistors
- 9 Measuring power using digitizing and TSP-Link
- 10 Troubleshooting FAQs
- About this section
- Where can I find updated drivers?
- Is there any software to help me get started?
- Why did my settings change?
- Why can't the DMM6500 read my USB flash drive?
- How do I upgrade the firmware?
- How do I change the command set?
- How do I save the present state of the instrument?
- How do I save what is displayed on the screen?
- What is the ethernet port number?
- 11 Next steps
- Contact information
Section
2: Front-panel overview Model DMM6500 6½ Digit Multimeter
User's Manual
2-14 DMM6500-900-01 Rev. B / August 2019
Menu overview
To access the main menu, press the MENU key on the DMM6500 front panel. The figure below
shows the organization of the main menu.
Figure 14: DMM6500 main menu
The main menu includes submenus that are labeled in green across the top of the display. Selecting
an option in a submenu opens an interactive screen.
Channel menu
The Channel menus allow you to set up and control channels and scans from the front panel.
The Channel Settings menu contains options to set up the measurement functions for each
channel.
The Channel Control menu contains options to open and close channels.
The Channel Scan menu contains options to set up and run scans. Options include control
of groups, which are channels that are sequential and have the same functions applied to
them.