Instructions
Table Of Contents
- Model DMM6500 6½-Digit Multimeter User's Manual
- 1 Introduction
- 2 Front-panel overview
- 3 Using a remote interface
- 4 Making basic front-panel measurements
- 5 Measuring DC voltage with high accuracy
- 6 Measuring 4-wire resistance with offset compensation
- 7 Scanning temperature at a set time interval
- 8 Grading and binning resistors
- 9 Measuring power using digitizing and TSP-Link
- 10 Troubleshooting FAQs
- About this section
- Where can I find updated drivers?
- Is there any software to help me get started?
- Why did my settings change?
- Why can't the DMM6500 read my USB flash drive?
- How do I upgrade the firmware?
- How do I change the command set?
- How do I save the present state of the instrument?
- How do I save what is displayed on the screen?
- What is the ethernet port number?
- 11 Next steps
- Contact information
Model DMM6500
6½ Digit Multimeter User's Manual Section 2: Front-
panel overview
DMM6500-900-01 Rev. B / August 2019 2-13
Figure 12: SCAN swipe screen - initial view
Figure 13: SCAN swipe screen - scan results
The SCAN swipe screen has the following control options:
Button Description
Abort Scan
Stop the scan.
Build Scan
Opens the SCAN screen, where you can set up a new scan.
Edit
Opens the SCAN screen, where you can change the setup of a scan.
Pause Scan
Pauses the scan until Resume Scan is selected.
Resume Scan
Resumes a paused scan.
Save to USB
Saves the data in the scan reading buffer to a CSV file on the USB flash drive.
Start Scan
Runs a scan.
Step Scan
Incrementally steps through a scan, channel by channel.