Instructions
Table Of Contents
- Model DMM6500 6½-Digit Multimeter User's Manual
- 1 Introduction
- 2 Front-panel overview
- 3 Using a remote interface
- 4 Making basic front-panel measurements
- 5 Measuring DC voltage with high accuracy
- 6 Measuring 4-wire resistance with offset compensation
- 7 Scanning temperature at a set time interval
- 8 Grading and binning resistors
- 9 Measuring power using digitizing and TSP-Link
- 10 Troubleshooting FAQs
- About this section
- Where can I find updated drivers?
- Is there any software to help me get started?
- Why did my settings change?
- Why can't the DMM6500 read my USB flash drive?
- How do I upgrade the firmware?
- How do I change the command set?
- How do I save the present state of the instrument?
- How do I save what is displayed on the screen?
- What is the ethernet port number?
- 11 Next steps
- Contact information
Section
2: Front-panel overview Model DMM6500 6½ Digit Multimeter
User's Manual
2-8 DMM6500-900-01 Rev. B / August 2019
Figure 5: DMM6500 swipe screens, maximized and minimized
# Screen element Description
1
Minimize indicator
You can swipe down to minimize the swipe screens.
2
Swipe screen indicator
Each circle represents one swipe screen. As you swipe right or left, a different
circle changes color, indicating where you are in the screen sequence. Select a
circle to move the swipe screen without swiping.
3
Calculations shortcut
Select to open the CALCULATION SETTINGS menu. Only available when
TERMINALS is set to FRONT.
4
Measure Settings
shortcut
Select to open the MEASURE SETTINGS menu for the selected function. Only
available when TERMINALS is set to FRONT.
5
Restore indicator
Indicates that you can swipe up to display the swipe screen.
6
Graph shortcut
Select to open the Graph screen.
Channel Settings
shortcut
Not shown. Select to open the CHANNEL SETTINGS screen. This shortcut is
on the settings swipe screen when there is an active closed channel and the
terminals are set to rear.
Scan shortcut
Not shown. Select to open the SCAN screen. This shortcut is available when
the terminals are set to rear.
Channel control shortcut
Not shown. Select to open the CHANNEL CONTROL screen. This shortcut is
available when the terminals are set to rear.