Datasheet

www.keithley.com
1.888.KEITHLEY (U.S. only)
A GREATER MEASURE OF CONFIDENCE
Overview
SWITCH/MEASURE SYSTEMS
4
Integra Series Multimeter/Switch Systems
Measure the ratio
or average of two
input channels.
View a channel of
interest without
interrupting a
scan by using the
Channel Monitor
feature.
Built-in
linearization for
thermocouples,
RTDs, and
thermistors.
Front panel input jacks simplify
manual probing, troubleshooting,
and calibration. Built-in signal
conditioning with 1000V isolation
simplifies system configuration and
ensures good measurements.
Familiar DMM-like front panel
scheme makes it easier to use on
bench or rack. Select or change
functions with the simple push
of a button.
Set the number
of digits to be
displayed as well
as the reading
rate.
Non-volatile
memory allows
time-stamped
storage of 55k
readings.
Manually step
through channels
or scan
automatically.
Configure each
channel
independently.
Initialize the system
with one of four fully
programmable set-up
conditions. System
configuration is
stored in non-volatile
memory.
Use mX+b or %
scaling to convert
sensor/transducer
outputs directly
into engineering
units.
Built-in digital I/O lines provide for
control, external triggering, and
HI/LO alarm/limit outputs.
Trigger Link enables tightly
synchronized triggering with other
instruments in large ATE systems
GPIB and RS-232
interfaces are
standard.
Built-in noise rejection circuitry
ensures stable, predictable
measurements.
Rugged 50-pin D-sub
connectors ensure dependability
and quick setup/teardown in
production test racks.
A variety of measurement and control modules let you
mix, match, and change input signals or control lines
any time you like. Install up to two modules at a time
to create up to an 80-channel “mini-ATE” system.
Model 2700