Datasheet

www.keithley.com
1.888.KEITHLEY (U.S. only)
A GREATER MEASURE OF CONFIDENCE
Model 7712 Specifications
SWITCH/MEASURE SYSTEMS
35
Integra Series Multimeter/Switch Systems
Modules
7712 3.5GHz 50Ω RF MODULE
FEATURES
• 3.5GHz bandwidth
• Dual 1×4 configuration
• Rear panel SMA connections
• On-board switch closure counter
• On-board S-parameter storage
Typical Insertion Loss
0dB
–1dB
–2dB
–3dB
–4dB
10 100 1000 4000
Frequency (MHz)
Typical VSWR
1.8
1.6
1.4
1.2
1.0
10 100 1000 4000
Frequency (MHz)
AC PERFORMANCE (End of Life)
For Z
load
= Z
source
= 50Ω
<500 MHz 1 GHz 2.4 GHz 3.5 GHz
Insertion Loss <0.5 dB <0.65 dB <1.1 dB <1.3 dB
MAX
VSWR MAX <1.15 <1.2 <1.45
2
<1.45
Ch-Ch Crosstalk
1
–75 dB –70 dB –50 dB –45 dB
MAX
1
Specification assumes 50Ω termination.
2
Add 0.1VSWR after 5×10
5
closures (no load).
INPUTS (CHANNELS 1-8)
MAXIMUM SIGNAL LEVEL: Any channel to any channel or chassis (1–8): 30Vrms
(42V peak for AC waveforms) or 42VDC, 0.5A.
MAXIMUM POWER: 20W per module, 10W per channel (refer to 7711/7712 Manual
PA-818 for measurement considerations).
SAFETY: Conforms to European Union Directive 73/23/EEC EN61010-1, CAT I.
EMC: Conforms with European Union Directive 89/336/EEC; EN61326-1.
ISOLATION: Multiplexer to Multiplexer: >1GΩ.
Center to Shield: >1GΩ, <20pF.
Channel to Channel: >100MΩ.
CONTACT LIFE: 5×10
6
no load, 1×10
5
rated load (resistive load).
CONTACT POTENTIAL: <12µV.
CONTACT RESISTANCE: <0.5Ω (initial), <1Ω (end of life).
RISE TIME: <200ps (guaranteed by design).
SIGNAL DELAY: <1.5ns.
GENERAL
RELAY TYPE: High frequency electromechanical.
CONTACT CONFIGURATION: Dual 1×4 multiplexer, single pole four throw, Channels
1 and 5 are normally closed.
NOTES: One channel in each multiplex bank is always closed to the corresponding
OUT connector.
CLOSE CHANNEL: ROUTe:CLOSe allows a single channel in a multiplex bank to be
closed. ROUTe:MULTiple:CLOSe allows two channels (one in each bank) to be
closed at one time.
OPEN CHANNEL: ROUTe:OPEN:ALL closes CH1 and CH5 to OUT A and OUT B
respectively.
ACTUATION TIME: <10ms.
FIRMWARE: Specified for Model 2700 rev. B04, 2701 rev. A01, and 2750 rev. A03
or higher.
CONNECTOR TYPE: Ten external rear panel SMA connectors.
MATING TORQUE: 0.9 N·m (8 in-lb).
ENVIRONMENTAL
OPERATING ENVIRONMENT: Specified for 0°C to 50°C. Specified for 80% RH at 35°C.
STORAGE ENVIRONMENT: –25°C to 65°C.
WEIGHT: <0.5kg (1.1 lb).
ACCESSORIES AVAILABLE
7712-SMA-1 SMA Cable, male to male, 1m (3.3 ft)
7712-SMA-N Female SMA to Male N-Type Adapter
S46-SMA-0.5 SMA Cable, male to male, 0.15m (0.5 ft.)
S46-SMA-1 SMA Cable, male to male, 0.3m (1 ft.)