Datasheet

Model 4299-8 Single Fixed Rack-Mount Kit
6 071314400 / June 2013
Step 2: Prepare the instrument
To prepare a Graphical Display instrument for rack mounting, remove the handle and bumpers (if installed),
and then install the mounting hardware.
Remove handle and bumpers from the Graphical Display instrument
To remove the handle and bumpers (if installed):
1. While pulling the ends of the handle (1) away from the sides of the instrument, swing the handle to the
upright position (the upright position is illustrated in the figure).
2. With the handle aligned in the upright position, pull the ends of the handle away from the case and remove.
3. Remove the screws and the handle mounts (2) from both sides of the instrument.
4. Pull on one of the front bumper corners (3) and remove the front bumper from the instrument.
5. Remove the rear bumper (4) the same way as you removed the front bumper.
6. Store the handle, bumpers, and hardware for future bench-top use.
Figure 5: Remove handle and bumpers
You can install the instrument on either side of the rack. The following steps outline installation of the
Graphical Display instrument on the left side of the rack. To locate the instrument on the right side,
switch the location of the front-rack ear (2450-360) with the half-rack blank panel (2450-362).