Datasheet

Model 4299-3 Installation Instructions
PA-942 Rev. A / May 2007 3
Figure 1
Remove handle and mounting ears
2. Remove both rear feet from the instrument by pulling out the rubber feet and then removing the screws
underneath.
NOTE Do not re-install the feet mounting screws. Save all parts removed for future bench top
use of the instrument.
Step 2. Install mounting hardware to instrument
NOTE The instrument may be installed on the rack’s right side with the half rack
front panel on the left side as shown in the following illustrations, or on the
rack’s left side with the half rack front panel on the right side (not shown..)
1. Determine and select the unit’s side that is to be installed closest to the rack rail (see Note above).
2. Secure Front Rack Ear (2602-333) using two Pan Head Screws** (refer to Figure 2).
3. Secure the Half Rack Front Panel (2602-344) to the other side of the instrument using the two remaining
Pan Head Screws**.
Mounting ear
Screw
Handle
Mounting ear