User Manual

Section
2: Installation and connections Model 3760 10-Channel High Current Multiplexer Card
User's Manual
2-2 3760-900-01 Rev. A / July 2017
Card connectors
You can make signal input and output connections with the screw terminal connectors on the card.
The locations for each channel input and the card output are located outside of the card.
All connections will need to be made before the card is installed in the mainframe. Because the card
is rated at higher voltage than the mainframe, no backplane connectors are provided internal to the
card. Ensure that any signals connected to the multimeter or mainframe are limited to the allowable
ratings of the device. For more information about wire connections, see
Wire selection and
preparation (on page 3-2).
Figure 2: Model 3760 screw terminal connectors