User manual

Section 12: Status Model Series 3700 System Switch/Multimeter Reference Manual
12-22 3700S-901-01 Rev. C / July 2008
Commands
Bit
status.operation.user.* = status.operation.user.BIT1
B1
status.operation.user.* = status.operation.user.BIT2
B2
status.operation.user.* = status.operation.user.BIT3
B3
status.operation.user.* = status.operation.user.BIT4
B4
status.operation.user.* = status.operation.user.BIT5
B5
status.operation.user.* = status.operation.user.BIT6
B6
status.operation.user.* = status.operation.user.BIT7
B7
status.operation.user.* = status.operation.user.BIT8
B8
status.operation.user.* = status.operation.user.BIT9
B9
status.operation.user.* = status.operation.user.BIT10
B10
status.operation.user.* = status.operation.user.BIT11
B11
status.operation.user.* = status.operation.user.BIT12
B12
status.operation.user.* = status.operation.user.BIT13
B13
status.operation.user.* = status.operation.user.BIT14
B14
To read registers:
print(status.operation.user.*)
Where * = .ntr, .ptr, .enable, .event, and .condition
NOTE The first three (.ntr, .ptr, and .enable) are read/write, while the last two
(.event and .condition) are read only.
print(status.operation.user.condition)
print(status.operation.user.event)