User manual

Series 3700 System Switch/Multimeter Reference Manual Section 2: TSP Programming Fundamentals
3700S-901-01 Rev. C / July 2008 2-13
USB connection
Connect a computer controller to the Series 3700 rear panel USB (from host)
connector (connect USB flash drive devices to the Series 3700 front panel
USB). Refer to Rear panel summary (on page 2-10) for connector location.
NOTE For your Series 3700 to be recognized by your computer over the
USB interface, the proper driver must be installed. Installing the Test
Script Builder application also installs the applicable USB driver (it
becomes available after installing this software). To complete the USB
driver installation, after installing the Test Script Builder application,
connect the Series 3700 USB connector (rear panel) to the computer.
Using Test Script Builder (TSB)
Test Script Builder is a supplied software tool that can be used to perform the
following operations:
Send ICL commands and TSL statements
Receive responses (data) to commands and scripts
Create and run user scripts
The following figure shows an example of the Test Script Builder. As shown, the
Workspace is divided into three window panes:
Project Navigator (on page 2-14)
Script Editor (on page 2-14)
Programming interaction (on page 2-15)