User manual

Series 3700 System Switch/Multimeter Reference Manual Section 8: Scanning
3700S-901-01 Rev. C / July 2008 8-11
When removing channels, channel patterns will not be checked to determine if
the channel being removed is associated with its image. To remove a channel
pattern in a scan list, select the channel pattern to be removed, and then press
the DELETE key. Continuing the previous example of Channel 3003, if 'mypat1'
is comprised of Channels '3003, 3033, 3911, and 3922' when the remove
request for Channel 3003 is made, it will not remove 'mypat1' from the list. To
remove 'mypat1' from list, select the channel pattern 'mypat1' and press the
DELETE key, which removes the step and all associated channels.
Press the STEP key to single step through a scan list.
Scan configuration
To configure a scan from the SCAN ATTR MENU, while in an active scan
list:
1. Press the CONFIG key.
2. Press the SCAN key. Modify any of the following menu items as desired:
ADD: Displays Use <INSERT> key. The related ICL is scan.add,
without the optional DMM configuration.
BYPASS: Enables (ON) or disables (OFF) bypassing the first step of the
first scan pass. Related ICL command: scan.bypass (on page 13-
233).
MODE: Sets the scan mode value to one of the following:
OPEN_ALL (default setting)
OPEN_SELECT
FIXED_ABR
Related ICL command: scan.mode() (on page 13-239).
MEAS_CNT: Sets the measure count value. Related ICL command:
scan.measurecount (on page 13-238).
SCAN_CNT: Sets the scan count value. Related ICL command:
scan.scancount (on page 13-242).
3. Press the EXIT key to leave the menu.