User manual

Section 4: Using the Front Panel Series 3700 System Switch/Multimeter Reference Manual
4-28 3700S-901-01 Rev. C / July 2008
MENU key
Press the MENU key to open the MAIN menu.
The MAIN menu contains the following items:
SCRIPT: Opens the SCRIPT menu that contains LOAD and SAVE menu
items.
SETUP: Opens the SETUP menu that contains SAVE, RECALL,
POWERON, and RESET menu items.
GPIB: Opens the GPIB menu that contains ADDRESS and ENABLE menu
items.
LAN: Opens the LAN menu that contains STATUS, CONFIG, APPLY,
RESET, and ENABLE menu items.
TSPLINK: Opens the TSPLINK menu that contains NODE and RESET
menu items.
UPGRADE: Upgrades the firmware on the unit and installed cards (see
Upgrade procedure using USB flash drive). This menu includes three
options (YES, NO, and PREVIOUS).
CHANNEL: Opens the CONNECT menu that allows you to select a rule
(BBM, MBB, or OFF), or to connect sequentially (ON or OFF setting).
Related ICL commands: channel.connectrule (on page 13-39) and
channel.connectsequential (on page 13-40).
DISPLAY: Opens the DISPLAY menu. Select the TEST item to open the
DISPLAY TESTS menu, which contains KEYS and DISPLAY-PATTERNS
menu items. Use KEYS to verify the operation of the keys. Use DISPLAY-
PATTERNS to verify each segment of the display.
DIGIO: Opens the DIGIO I/O menu that is used to set DIGIO-OUTPUT and
WRITE-PROTECT menu items.
BEEPER: Enables or disables the beeper, along with selection KEYCLICK
option.
SYSTEM-INFO: Opens the SYSTEM INFORMATION menu that can query
FIRMWARE, SERIAL#, and CAL information.