User manual

Series 3700 System Switch/Multimeter Reference Manual Section 4: Using the Front Panel
3700S-901-01 Rev. C / July 2008 4-23
INPUTDIV
Enables or disables the 10M input divider. Related ICL command:
dmm.inputdivider (on page 13-140).
LIMIT
Opens the LIMIT menu for the selected DMM function. See LIMIT key
configuration (on page 4-27).
LINESYNC
Enables or disables line sync during measurements.
Related ICL command: dmm.linesync (on page 13-144).
MATH
Selecting the MATH menu item opens the MATH MENU. Items contained in this
menu are:
ENABLE: Enables or disables math operation on measurements. Related
ICL command: dmm.math.enable (on page 13-147).
FORMAT: Specifies the math operation to perform on measurements.
Related ICL command: dmm.math.format (on page 13-147).
BFACTOR: Specifies the offset for the y = mX + b operation. Related ICL
command: dmm.math.mxb.bfactor (on page 13-148).
MFACTOR: Specifies the scale factor for the y = mX + b operation. Related
ICL command: dmm.math.mxb.mfactor (on page 13-149).
MXBUNITS: Specifies the unit character for the y = mX + b operation.
Related ICL command: dmm.math.mxb.units (on page 13-149).
PERCENT: Specifies the constant to use for the percent operation. Related
ICL command: dmm.math.percent (on page 13-150).
For more information, see:
mX+b (on page 6-4)
Reciprocal (1/X) (on page 6-7)
Percent (on page 6-6)
NPLC
Configures the integration rate in line cycles for the DMM. Related ICL
command: dmm.nplc (on page 13-152).
OFFSETCOMP
Configures the offset compensation setting for the DMM. Related ICL command:
dmm.offsetcompensation (on page 13-153).