User manual

Series 3700 System Switch/Multimeter Reference Manual Section 4: Using the Front Panel
3700S-901-01 Rev. C / July 2008 4-15
POWER
Sets the power state attribute on a channel. Select one of the following options:
ENABLE
DISABLE
Related ICL command: channel.setpowerstate() (on page 13-80)
CONFIG CHAN key - DAC channel type
Press the CONFIG CHAN key to open the DAC ATTR menu. The DAC ATTR
menu is not available when a range of channels is selected. If a range is
selected, pressing CONFIG CHAN displays the following:
DAC ATTR MENU
<No Edit by Range, Use EXIT>
Therefore, to see the following options, select a single DAC channel.
NOTE If the DAC channel has power set to DISABLE, then the menu choices
change to only show the option to change the power setting, until the
power is set to ENABLE.
LABEL
Enter up to 12 characters for the label for a channel. Related ICL command:
channel.setlabel() (on page 13-74).
DELAY
Enter the value for the delay in 1ms steps from 0 to 60 seconds for a channel.
Related ICL command: channel.setdelay() (on page 13-72).