User manual

A-14 Return to Section Topics 3390-900-01 Rev. C / January 2009
Appendix A: SCPI Command Reference Model 3390 Arbitrary Waveform Generator User’s Manual
:STOP {<frequency> | MINimum |
MAXimum}
See Frequency sweep.
:STOP? [MINimum | MAXimum]
Query the sweep stop frequency.
:CENTer {<frequency> | MINimum |
MAXimum}
See Frequency sweep.
:CENTer? [MINimum | MAXimum]
Query the sweep center frequency.
:SPAN {<frequency> | MINimum |
MAXimum}
See Frequency sweep.
:SPAN? [MINimum | MAXimum]
Query the sweep span frequency.
SWEep
:SPACing {LINear | LOGarithmic}
See Frequency sweep.
:SPACing?
Query the sweep spacing.
:TIME {<seconds> | MINimum |
MAXimum}
See Frequency sweep.
:TIME? [MINimum | MAXimum]
Query the sweep time.
:STATe {OFF | ON}
See Frequency sweep.
:STATe?
Query the on/off state of sweep.
TRIGger
:SOURce {IMMediate | EXTernal |
BUS}
See Frequency sweep.
:SOURce?
Query the trigger source.
:SLOPe {POSitive | NEGative}
See Frequency sweep.
:SLOPe?
Query the trigger slope.
OUTPut
:TRIGger:SLOPe {POSitive | NEGative}
See Frequency sweep.
:TRIGger:SLOPe?
Query the edge for the trigger out signal.
:TRIGger {OFF | ON}
See Frequency sweep.
:TRIGger?
Query the on/off state of trigger out.
MARKer
:FREQuency {<frequency> | MINimum |
MAXimum}
See Frequency sweep.
:FREQuency? [MINimum | MAXimum]
Query the marker frequency.
MARKer {OFF | ON}
See Frequency sweep.
MARKer?
Query the on/off state of the frequency
marker.
Burst commands
Command Parameters Definition
BURSt
:MODE {TRIGgered | GATED}
See Burst operation.
:MODE?
Query the burst mode.
:NCYCles {<# cycles> | INFinity |
MINimum | MAXimum}
See Burst operation.
:NCYCles? [MINimum | MAXimum]
Query the burst count.
:INTernal:PERiod {<seconds> | MINimum |
MAXimum}
See Burst operation.
:INTernal:PERiod? [MINimum | MAXimum]
Query the burst period.
:PHASe {<angle> | MINimum |
MAXimum}
See Burst operation.
:PHASe? [MINimum | MAXimum]
Query the burst starting phase.
Table A-6:
SCPI command summary