User manual

A-10 Return to Section Topics 3390-900-01 Rev. C / January 2009
Appendix A: SCPI Command Reference Model 3390 Arbitrary Waveform Generator User’s Manual
VOLTage
{<amplitude> | MINimum |
MAXimum}
See Sine waveform, Square waveform,
Ramp waveform, Pulse waveform, Noise
waveform, Amplitude modulation,
Frequency modulation, Phase
modulation, Frequency-shift keying
modulation, Pulse width modulation
waveform.
VOLTage?
[MINimum | MAXimum]
Query the output amplitude for the
current function.
VOLTage
:OFFSet
{<offset> | MINimum |
MAXimum}
See Sine waveform, Square waveform,
Ramp waveform, Pulse waveform, Noise
waveform, Amplitude modulation,
Frequency modulation, Phase
modulation, Frequency-shift keying
modulation, Pulse width modulation
waveform.
:OFFSet?
[MINimum | MAXimum]
Query the DC offset voltage for the
current function.
:HIGH {<voltage> | MINimum |
MAXimum}
See Setting pulse high and low levels.
:HIGH? [MINimum | MAXimum]
Query the high voltage level.
:LOW {<voltage> | MINimum |
MAXimum}
See Setting pulse high and low levels.
:LOW? [MINimum | MAXimum]
Query the low voltage level.
:RANGe:AUTO {OFF | ON | ONCE}
See Setting voltage auto ranging.
:RANGe:AUTO?
Query the auto-ranging state.
:UNIT {Vpp | Vrms | dBm}
See Setting amplitude.
:UNIT?
Query the output amplitude units.
FUNCtion
:SQUare:DCYCle {<percent> | MINimum |
MAXimum}
See Square waveform.
:SQUare:DCYCle? [MINimum | MAXimum]
Query the current duty cycle percentage.
:RAMP:SYMMetry {<percent> | MINimum |
MAXimum}
See Ramp waveform.
:RAMP:SYMMetry?
[MINimum | MAXimum]
Query the current symmetry setting
percentage.
OUTPut {OFF | ON}
See Controlling the output signal.
OUTPut?
Query the on/off state of the Output
connector.
OUTPut
:LOAD {<ohms> | INFinity |
MINimum | MAXimum}
See Setting output termination.
:LOAD? [MINimum | MAXimum]
Query the current load setting in ohms.
:POLarity {NORMal | INVerted}
See Setting waveform polarity.
:POLarity?
Query the waveform polarity.
:SYNC {OFF | ON}
See Controlling the sync signal.
:SYNC?
Query the on/off state of the Sync
connector.
Pulse configuration commands
Command Parameters Definition
Table A-6:
SCPI command summary