User manual

4-8 Return to Section Topics 3390-900-01 Rev. C / January 2009
Section 4: Setup Basics Model 3390 Arbitrary Waveform Generator User’s Manual
Default settings
Table 4-3 shows the factory default settings for the Model 3390. These settings will be recalled at
power up unless you set the instrument to enable a stored state.
Table 4-3:
Factory default settings
Output configuration Default setting
Function Sine waveform
Frequency 1 kHz
Amplitude/offset 100 mV peak-to-peak/0.000 V DC
Output units V peak-to-peak
Output termination 50 Ω
Auto range On
Modulation settings
Carrier 1 kHz Sine (AM, FM, PM, FSK)
1 kHz Pulse (PWM)
Modulation waveform (AM) 100 Hz Sine
Modulation waveform (PM, FM, PWM) 10 Hz Sine
AM depth 100%
FM deviation 100 Hz
PM deviation 180°
FSK hop frequency 100 Hz
FSK rate 10 Hz
PWM width deviation 10
μs
Modulation state Off
Sweep settings
Start/stop frequency 100 Hz/1 kHz
Sweep time 1 s
Sweep mode Linear
Sweep state Off
Burst settings
Burst count 1 cycle
Burst period 10 ms
Burst start phase 0°
Burst state Off
System-based operations
Power-down recall Disabled
Display mode On
Error queue 0 errors
Output state Off
Triggering operations
Trigger source Internal (immediate)
Remote interface configuration
GPIB address 16
DHCP On