Datasheet

Datasheet
TEK.COM12
Noise, 10 Hz–20 MHz (6 V Range) <30 mV peak-peak (typical).
Voltage Source Range Change Overshoot
<400 mV + 0.1% of larger range (typical). Overshoot into a 100 kΩ load, 20 MHz BW.
General (2601B, 2602B, 2604B)
IEEE-488 IEEE-488.1 compliant. Supports IEEE-488.2 common commands and status model topology.
USB Control (rear) USB 2.0 device, TMC488 protocol.
RS-232 Baud rates from 300 bps to 115200 bps.
Ethernet RJ-45 connector, LXI Class C, 10/100BT, no auto MDIX.
Expansion Interface The TSP-Link expansion interface allows TSP enabled instruments to trigger and communicate with each
other. (Not available on 2604B.)
Cable Type Category 5e or higher LAN crossover cable.
Length 3 meters maximum between each TSP enabled instrument.
LXI Compliance LXI Class C 1.4.
LXI Timing Total Output Trigger Response Time: 245 µs min., 280 µs typ., (not specified) max.
Receive LAN[0-7] Event Delay: Unknown.
Generate LAN[0-7] Event Delay: Unknown.
Digital I/O Interface (Not available on Model 2604B)
+5VDC
5.1kΩ
100Ω
Solid State
Fuse
Read by
firmware
Written by
firmware
+5V Pins
(on DIGITAL I/O
connector)
Digital I/O Pi n
(on DIGITAL I/O
connector)
GND Pin
(on DIGITAL I/O
connector)
Rear Panel
Connector 25-pin female D.
Input/Output Pins 14 open drain I/O bits.
Absolute Maximum Input Voltage
5.25 V.
Absolute Minimum Input Voltage
– 0.25 V.
Maximum Logic Low Input Voltage
0.7 V, +850 µA max.
Minimum Logic High Input Voltage
2.1 V, +570 µA.
Maximum Source Current (flowing out of Digital I/O bit)
+960 µA.
Maximum Sink Current @ Maximum Logic Low Voltage (0.7V)
–5.0 mA.
Absolute Maximum Sink Current (flowing into Digital I/O pin)
–11 mA (not including 2604B).
5V Power Supply Pins Limited to 250 mA total for all three pins, solid state fuse protected.
Output Enable Active high input pulled down internally to ground with a 10 kΩ resistor; when the output enable input
function has been activated, each SourceMeter channel will not turn on unless the output enable pin is
driven to >2.1 V (nominal current = 2.1 V/10 kΩ = 210 µA).