User manual

Series 2600B
System SourceMeter® Instrument Reference Manual Section 7:
TSP command reference
2600BS-901-01 Rev. B / May 2013 7-145
localnode.showerrors
This attribute sets whether or not the instrument automatically sends generated errors.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW)
Yes
Power cycle
Not saved
0 (disabled)
Usage
errorMode = localnode.showerrors
localnode.showerrors = errorMode
errorMode
Enables (1) or disables (0) the show errors state
Details
If this attribute is set to 1, the instrument automatically sends any generated errors stored in the error queue, and
then clears the queue. Errors are processed after executing a command message (just before issuing a prompt,
if prompts are enabled).
If this attribute is set to 0, errors are left in the error queue and must be explicitly read or cleared.
When using this command from a remote node, localnode should be replaced with the node reference, for
example, node[5].showerrors.
Example
localnode.showerrors = 1
Enables sending of generated errors.
Also see
localnode.prompts (on page 7-141)
makegetter()
This function creates a function to get the value of an attribute.
Type TSP-Link accessible
Affected by Where saved Default value
Function
No
Usage
getter = makegetter(table, attributeName)
getter
The return value
table
Read-only table where the attribute is located
attributeName
A string representing the name of the attribute