User Manual

1-14 Getting Started 2400 Series SourceMeter

User’s Manual

With the voltage (V) or current (I) measurement function selected, the TOGGLE

key lets you display both the current and voltage measurements at the same time.

It also allows you to toggle display positions of the source and measure readings.

With the ohms (Ω) measurement function selected, the ohms measurement is

always displayed on the top display. The TOGGLE key lets you display either the

programmed source value, the current measurement, or the voltage

measurement on the bottom-left display.

The TOGGLE key is also used to display statistical data on readings stored in the

data store. This function is performed from the data store RECALL mode.

NOTE If FCTN, REL, or Limits is enabled, the TOGGLE key is disabled.

Status and error messages

Status and error messages are displayed momentarily. During SourceMeter oper-

ation and programming, you will encounter a number of front panel messages.

Typical messages are either status or error in nature and are listed in Appendix B.

Remote display programming

The display can also be controlled by various SCPI :DISPlay subsystem com-

mands. See Section 18, “DISPlay subsystem,” for more information on using

these commands. See also “Disabling front panel display,” page 1-24.

Front panel tests

Use the TEST/FRONT-PANEL-TESTS selection of the main MENU to test various

aspects of the front panel. See “Menus,” page 1-19, for more information.