User Manual

2400 Series SourceMeter
®
User’s Manual Table of Contents
Bus lines ....................................................................................... D-5
Data lines ............................................................................... D-5
Bus management lines .......................................................... D-5
Handshake lines .................................................................... D-5
Bus commands ............................................................................ D-6
Addressed multiline commands ............................................. D-8
Address commands ............................................................... D-8
Unaddress commands ........................................................... D-8
Common commands .............................................................. D-8
SCPI commands .................................................................... D-8
Command codes .................................................................... D-9
IEEE command groups ........................................................ D-11
Interface function codes ............................................................. D-12
Introduction .................................................................................. E-2
Introduction ................................................................................... F-2
Overview ....................................................................................... F-2
Description .............................................................................. F-2
Operation ...................................................................................... F-3
DUT connections .................................................................... F-3
Contact check threshold resistances ...................................... F-4
Contact check failure indications ............................................ F-5
Auto and manual ohms ........................................................... F-5
Trigger model operation .......................................................... F-6
Sweep and binning considerations ............................................... F-6
Sweep limitations .................................................................... F-6
Limit test sequence ................................................................. F-7
Binning failure indications (grading mode) ............................ F-10
Front panel contact check operation ........................................... F-11
Menu selections .................................................................... F-11
Using contact check .............................................................. F-12
Remote contact check operation ................................................. F-14
Contact check remote commands ........................................ F-14
Contact check programming example .................................. F-15
Contact check command reference ............................................ F-17
Configure and control contact check .................................... F-17
Configure and control contact check limit test ...................... F-17
Configure and control contact check event detection ........... F-19
Contact check defaults ................................................................ F-20
Introduction .................................................................................. G-2
Selecting the 488.1 protocol ......................................................... G-2
Protocol differences ..................................................................... G-3
Message exchange protocol (MEP) ....................................... G-3
Using SCPI-based programs ................................................. G-4
NRFD hold-off ........................................................................ G-4
NDAC hold-off ........................................................................ G-4