User manual

Index 2400 Series SourceMeter User’s Manual
Limit testing 12-19
Math 8-6
Menus 1-19
Output configuration 13-7
Pulse Mode configuration 5-10
Pulse Mode sweep procedure 10-25
Relative 8-2
Sense selection 2-12
Source delay 3-13
Source-measure procedure 3-15
Speed control 7-7
Sweep 10-12
Terminals selection 2-2
Triggering 11-2
V-source protection 3-12
Front panel summary 1-6
Front panel tests 1-14
Front/rear terminals selection 2-2
Fuse replacement 1-11
G
Getting started 1-1
GPIB
Connections 14-4
Front panel operation 14-5
Operation 14-4
Primary address 14-4
Protocol differences G-3
Protocol selection G-2
Reading speed comparisons G-5
Standards 14-4
Status indicators 14-5
GPIB protocol G-1
Grading mode limits operation 12-4
Guard 6-27
Cable 2-8, 6-27
Methods 2-8
Ohms 2-9, 6-28
Selection 2-13
Sense 6-32
Sense selection 2-12
H
Handler
Interface 12-10
Types 12-12
I
IEEE-488 bus
Commands D-6
Description D-3
Interface function codes D-12
Lines D-5
Overview D-1
Inspection 1-3
Interlock, see Output Enable 13-6
I-Source operating boundaries 6-15
L
Limit 1 test (compliance) 12-3
Limit 2 (course limits) 12-2
Limit testing 12-1
Binning 12-4
Configuring 12-16
Data flow 12-3
Front panel operation 12-19
Grading mode 12-4
Modes 12-3
Operation 12-4
Pass/fail information 12-2
Programming example 12-22
Remote operation 12-20
Sorting mode 12-7
Types 12-2
Limits 3, 5-12 (fine limits) 12-2
Line power
Connection 1-9
Frequency 1-11
Linear staircase sweep 10-2
LOCAL key 14-6
Logarithmic staircase sweep 10-4
Long-form and short-form versions 14-9
M
Manual ranging 7-2
Math 8-4
Built-in functions 8-4
Front panel operation 8-6
Remote operation 8-7
User-defined functions 8-7
Measure only
Remote operation 3-21
Measure voltage or current 3-20
memory sweep 18-93
Menus 1-19
Configuration 1-24
Main 1-19
Navigating 1-22
Message
Program 14-10
Response 14-12
Status and error B-2