User manual

2400 Series SourceMeter
®
User’s Manual Contact Check Function F-11
will start with a contact check for each sweep point and normal measurement
operation if no other failures occur.
Auto clear off, immediate binning
Bin control at end of each point is sweep: :CALC2:CLIM:BCON IMM
The output will remain on between each sweep point if no contact check failure
occurs. If a contact check failure occurs before the execution of a sweep point, the
output will be turned off for that point. The test sequence will progress and per-
form a contact check on the next point in the sweep. The output will not be turned
on until a good contact is detected.
Front panel contact check operation
Menu selections
Tab l e F - 2 summarizes the menu selections for various contact check modes. Note
that only those selections specific to contact check operation are shown here. See
Section 1 for complete menu listings, and Section 11 and Section 12 for details on
triggering and limit testing, respectively.
Table F-2
Contact check menu selections
Menu item* Description
CONFIG LIMIT Configure limit tests.
CONFIGURE LIMITS MENU
DIGOUT Set Digital I/O modes.
SIZE Select 3-BIT or 4-BIT fail pattern size.
MODE Select GRADING or SORTING mode.
H/W LIMITS Control and set mode for Limit 1 and Limit 4 tests.
LIMIT1(CMPL) Select Limit 1 (compliance) test.
LIMIT4(CCHK) Select Limit 4 (contact check) test.
CONTROL Enable/disable Limit 4 test.
DISABLE Disable contact check limit test.
ENABLE Enable contact check limit test.
DIGIO PATTERN Set contact check Digital I/O pattern.
Default Setting:0-7, 3-bit, alternately 0-15, 4-bit.