User manual

18-88 SCPI Command Reference 2400 Series SourceMeter
®
User’s Manual
2420
<n> = -6.3 to 6.3 Set I-Source level (amps)
-128 to 128 Set V-Source level (volts)
DEFault 0A or 0V
MINimum -6.3A or -128V
MAXimum +6.3A or +128V
2425 and 2430 DC Mode
<n> = -6.3 to 6.3 Set I-Source level (amps)
-210 to 210 Set V-Source level (volts)
DEFault 0A or 0V
MINimum -6.3A or -210V
MAXimum +6.3A or +210V
2430 Pulse Mode
<n> = -21 to 21 Set I-Source level (amps)
-210 to 210 Set V-Source level (volts)
DEFault 0A or 0V
MINimum -21A or -210V
MAXimum +21A or +210V
2440
<n> = -10.5 to 10.5 Set I-Source level (amps)
-42 to 42 Set V-Source level (volts)
DEFault 0A or 0V
MINimum -10.5A or -84V
MAXimum +10.5A or +84V
Query :STEP Query step size for sweep
:STEP? DEFault Query *RST default level
:STEP? MINimum Query lowest allowable level
:STEP? MAXimum Query highest allowable level
Description This command is used to specify a step size for a linear sweep.
When the sweep is started, the source level changes in equal steps
from the start level to the stop level. A measurement is performed at
each source step (including the start and stop levels).
NOTE This command cannot be used for a logarithmic sweep. Use the :POINTs
command to set the source-measure points for a log sweep.
To avoid a setting conflicts error, make sure the step size is greater
than the start value and less than the stop value.
The number of source-measure points in a linear sweep can be cal-
culated as follows:
Points = [(Stop - Start) / Step] + 1|
Points = (Span / Step) + 1
An alternate way to set the source-measure points in a linear sweep
is to simply specify the number of source-measure points in the
sweep using the :POINts command.