User manual
1-18 Getting Started 2400 Series SourceMeter
®
User’s Manual
Remote setups
You can also save and recall setups via remote using the following SCPI com-
mands:
• Save and recall user setups using *SAV and *RCL (Section 16).
• Restore GPIB defaults using *RST (Section 16).
• Restore bench defaults using :SYSTem:PRESet (Section 18).
• Save the power-on configuration using :SYSTem:POSetup (Section 18).
Voltage protection NONE
Triggered source:
Control Disabled
Scale factor +1.0
Triggering:
Arm layer:
Event Immediate
Count 1
Output trigger Line #2, Off
Trigger layer:
Event Immediate
Count 1
Output triggers Line #2, All off
Delay 0.0 sec
* Model 2410 default off state is guard.
** For instruments with contact check option (denoted by a -C in model number).
Table 1-2 (cont.)
Factory default settings